AEM 30-3508 Infinity Plug & Play Harnesses - Honda 2000-2005 S2000 - Manual (Page 6)

6
© 2014 AEM Performance Electronics
P/N 30-3508
INFINITY EMS INSTALLATION
Step 1
First, make sure the Honda CD Player
activation code is recorded and also take
note of the radio presets. Next, open the
hood and disconnect the battery. Remember
to set the clock when reconnecting the
battery.
The stock ECU is located on the left-side
kick panel, as shown. Pop off and remove the
door sill (not pictured) and kick panel cover,
as shown.
Carefully unplug the 3 ECU connectors by
depressing the “thumb” lock on each
connector. Avoid excessive stress or pulling
on the wires, as this may damage the
harness.
Step 2
To remove the ECU, unscrew the two
mounting M6 bolts from the mounting
bosses (circled in blue) using a 10mm
socket wrench. These mounting bosses
will not be reused.
As depicted in the picture, the sheet
metal surface in the ECU location is not
entirely flat. However, the included
adhesive hook and loop (Velcro) will still
be used to hold the Infinity EMS in place
while 1 of the OEM ECU bolts will be
reused to secure it to the spare M6
mounting boss, circled in red.