AEM 30-2860 Coil-On-Plug COP Conversion Kit User Manual

Page 2

Page 2

10-2860 B Series COP Instructions RevB 111117

KIT CONTENTS

1 x 35-2840 IGNITER W/ BRACKET

1 x 30-3255 HONDA EPM

4 x 30-2850 COIL

1 x 35-3860 B SERIES COP HARNESS

1 x 35-3861 EPM HARNESS

2 x #6 MOUNTING SCREW

2 x DIELECTRIC GREASE

INSTALLATION TIPS

1. Read through the entire manual and instructions before beginning the

installation.

2. Disconnect the negative battery cable(s) before beginning any work.
3. Maintain a clean and neat work area throughout the installation.
4. When raising or working under a vehicle, use properly rated stands/jacks.
5. Make sure all connectors are fully seated and inserted.
6. Make sure all components and cables are routed and installed away from any

direct heat sources or sharp objects.

TABLE OF CONTENTS

• Installation

• EMS/ECU Configuration 8

• Jumper Settings

• Syncing The EMS Timing

• EMS Pin Locations

• Connector Pinouts

• Factory Tachometer Setup

• Specifications

• Recommended Parts

• Replacement Parts

• Warranty

INSTALLATION

Removing the Factory Ignition

Remove the spark plug wires from the distributor and cylinder head. Unplug the
distributor from the factory wiring harness and remove the distributor from the engine.
The distributor is held in place by three mounting bolts. See Figure 1 below.