Belkin F5D7230AU4P - Manual (Page 132)

131 130
Troubleshooting
131 130
Troubleshooting
2. Both wired and wireless computers:
Make sure that the
network card’s TCP/IP settings are set to obtain an IP address
automatically. See the Router’s manual for tips on checking
and changing your settings. If the IP address assigned to the
computer’s network card are different than the Router’s settings,
this will cause a problem.
3. Wireless Computers: Be sure that the wireless computer is
connected to your network. Your network has a network name
(also called SSID). The default name of the Belkin Router is
“belkin54g”. It may be possible that there are multiple wireless
networks in your area. To confirm that you are connected to your
own network, and not a neighbouring one, use your wireless
networking utility to scan for wireless networks. If more than one
network is found, choose your network from the list and connect
to it.
4. Wireless Computers:
If you are using wireless security such as
WEP encryption, WPA security, or MAC address filtering, make
sure that your computer is configured for the correct security
settings. If you are using MAC address filtering on the Router,
make sure that the computer’s MAC address is entered in the
“Allow List”.
What’s the difference between 802.11b, 802.11g and 802.11a?
Currently there are three levels of wireless networking standards,
which transmit data at very different maximum speeds. Each is based
on the designation 802.11x, so named by the IEEE, the board that is
responsible for certifying networking standards. The most common
wireless networking standard, 802.11b, transmits information at
11Mbps; 802.11a and 802.11g work at 54Mbps. See the following
chart for more detailed information.