Mueller Snap Lock (MSL) - Manual (Page 32)

32
FLOATING RAKE DETAILS
|
WOOD DECK
Installation steps continued:
4. Apply tri bead to the top of the Rake Trim Support Angle and install Rake Trim as shown with #14x 7/8” lap
screws on 6” centers.
5. Attach Rake Slide Trim over bottom edge of the Rake Trim securing with #9 woodgrip screws on 12” centers.
6. For last panel run, field cut the panel if necessary to form a 1 ¾” up turned leg that will position against the
slotted rake angle when installed. Then complete the trim using the above steps.
Mueller Snap Lock Panel
Rake Trim
14ga Slotted Rake Angle
#12 x 1 1/4" SD Tek
Hex with Washer
on 12" Centers
#14 x 1 1/4" SD Shoulder
Tek Screws on 12" Centers #9 Woodgrip
Screw
Rake Slide Trim
#14 x 7/8" Lap
Tek Screw on 6"
Centers
Underlayment
Wood Deck
Sealant
6"
Rake Trim Support Angle
Isometric View