Mueller Snap Lock (MSL) - Manual (Page 15)

15
FLOATING RAKE DETAILS
Installation steps:
1. To begin starting panel you must first attach the Slotted Rake Angle to the existing rake using #14x1¼” SD
Shoulder tek screws, 12” on center placing screw in the center of the slotted hole.
2. Place the female leg of the first panel over the upturned edge of the Slotted Rake Angle.
3. Install Rake Trim Support Angle as pictured using tri bead sealant and secure using #12x1¼” SD screws thru
the Rake Trim Support Angle, tri bead, panel leg and into the 14 ga. Slotted Rake Angle, 12” on center.
Tri-Bead Sealant Tri-Bead Sealant
Rake
Trim
Purlin
Rake Slide Trim
Screw
Rafter
#14 x 1 1/4 " SD
Shoulder Screw
on 12" Centers
Rake Angle
Mueller Snap
Lock Sheet
RPN Wall Sheets
#14 x 7/8" Lap Tek Screw
#14 x 7/8" Lap Tek
Rake Trim
Support Angle
#12 x 1 1/4" SD Tek
Hex with Washer on 12" Centers 14ga Slotted
Rake Angle
Optional Closure