Mueller Snap Lock (MSL) - Manual (Page 18)

18
FLOATING EAVE
Installation Steps: (use only with fixed ridge/hip)
1. Install either eave trim or optional gutter onto the eave strut using #10 x 1 self drill pan head screws, 3 per 10'.
2. Apply butyl tape sealant to top leg of the eave trim or gutter as shown.
3. Install edge plate over butyl tape sealant using #10 x 1 self drill pan head screws into the Eave Strut.
4. Field notch, hem and fold the panel and, then slide hemmed edge over edge plate as shown.
5. Attached clips as specified.
6. Seal the ends of the panel legs using tube sealant.
RPN
Wall
Sheets
Eave Strut
Mueller Snap
Lock Sheet
#14 x 7/8" Lap
Tek Screw
(for eave
trim only)
Eave Trim
Clip
Purlin
Edge Plate
#10 X 1" Pan Head
Self Drill Screw
Sealant
Optional
Gutter
Optional Closure