Mueller Snap Lock (MSL) - Manual (Page 26)

26
FLOATING HIGH SIDE EAVE
Installation Steps: (use only with fixed eave)
1. Using temporary clamps, attach backup channel to panel 2” below the eave strut. This step should
occur as panels are applied. Locate backup channel to accommodate attachment of rake trim.
2. Apply butyl tape sealant to the panel, centered on the backup channel.
3. Apply end dam and attach using #12 x 1 ¼ self drill screws on 4” centers.
4. Seal the end dam sides with tube sealant.
5. Apply butyl tape sealant to the top of the end dam.
6. Attach High side eave trim to the end dam using #14 x 7/8 lap screws on 6” centers as shown.
Mueller Snap
Lock Panel
Tape Sealant
Back Up Channel
End Dam
#12 x 1 1/4" Self Drill
Tek Screw with Washer
Tube Sealant on
Vertical Edges
Eave Strut
Rake Trim
#14 x 7/8" Lap
Optional Closure
Tek Screw
RPN Wall Sheet
Clip
#10 x 1" Pan Head
Self Drilling Screw
Tape
Sealant
#14 x 7/8" Lap
Tek Screw
2" Minimum
Clearance