GrimmSpeed Hood Struts - Manual

GrimmSpeed Install Guide Series
Installing the GrimmSpeed BRZ/FR-S Hood Strut Kit
Updated 1/17/13
Introduction: This guide will illustrate the installation of the GrimmSpeed BRZ/FRS
Hood Strut Kit. The difficulty here is relatively low, so take your time and enjoy the
job!
Tools: The tools listed below are suggested for this task (figure 1). Optional tools
are noted.
- 1/2in wrench
- 13mm wrench
- 10mm, 12mm, 13mm sockets
- Ratchet and extension
Figure 1: Tools
Tips: Deep well sockets aren’t required, but act like an extra extension, which can
make the install a bit easier.
Procedure:
1. Begin by collecting your tools and popping your hood. This’ll be quick!
10, 12, 13mm
13mm
1/2in