GrimmSpeed BRZ//FR-S Intake - Manual

GrimmSpeed Install Guide Series
Installing the GrimmSpeed BRZ/FR-S Intake
Updated 11/3/14
Introduction: This guide will illustrate the installation of the GrimmSpeed BRZ/FR-S
Intake system. The difficulty here is medium, so take your time and enjoy the job! Expect
to spend 30-60min, depending on level of experience.
Tools: The tools listed below are suggested for this task. Optional tools are noted.
- Flathead and phillips screwdrivers
- Pliers
- 10mm socket and accompanying extensions/ratchet
- 3mm allen wrench
- 4 mm allen wrench
Tips: Take care to follow the installation instructions very carefully when installing the
filter onto the intake tube. This measurement is quite important and will ensure that the
MAF sensor reads accurately!