GrimmSpeed Antenna Delete Plate User Manual
GrimmSpeed For the car

Antenna Delete Plate and optional amplified AM/FM antenna installation instructions:
Step 1. Unscrew the old antenna. Save the screws and the factory gasket as they will be reused.
Step 2. Take out the drivers side interior "A" pillar cover. Remove the door trim (kick panel). Also, peel back
the floor carpet.
See also other documents in the category GrimmSpeed For the car:
- 02-07 WRX Radiator Shroud (7 pages)
- 02-07 WRX Top Mount Intercooler (17 pages)
- 02-07 WRX/STi AOS (4 pages)
- 02-07 WRX/STi/Impreza Hood Struts (6 pages)
- 05-07 LGT Brake Master Cylinder Brace (5 pages)
- 08+ LGT AOS (9 pages)
- 38mm EWG (3 pages)
- 93-07 Impreza/WRX/STi Master Cylinder Brace (5 pages)
- Alternator Cover (4 pages)
- Battery Tie Down (3 pages)
- Brake Master Cylinder Brace (8 pages)
- BRZ//FR-S Intake (17 pages)
- BRZ/FR-S Pulley Cover (5 pages)
- Downpipe Install Guide (2 pages)
- Electronic Boost Controller Subaru (5 pages)
- Electronic Boost Controller EVO (6 pages)
- Electronic Boost Controller Hyundai (4 pages)
- Exhaust Manifold (2 pages)
- Gold Paint Guide (1 page)
- Heat Shield (3 pages)
- HiFlow CrossPipe (2 pages)
- Hood Struts (7 pages)
- Hyundai 160 Thermostat (2 pages)
- Hyundai Phenolic Spacer (3 pages)
- IWG Bracket (2 pages)
- License Plate (3 pages)
- License Plate Relocation (3 pages)
- Manual Boost Controller (4 pages)
- Mazdaspeed Electronic Boost Controller (11 pages)
- Strut Bar (4 pages)
- Subaru Lightweight Crank Pulley (14 pages)
- Subaru MAF Block Off (1 page)
- Subaru Reverse Downpipe Adapter (2 pages)
- Subaru Up pipe (3 pages)
- Top Mount Intercooler Splitter (2 pages)