SkyTrak 6036 Operation Manual - Manual (Page 62)

56 Model 6036
Operation
• Turn the ignition switch (Figure 34, 1) to the START (2) position to
engage the starter motor. After the engine has started to crank,
not before, the other person can begin spraying starting fluid into
the air cleaner intake (Figure 35, 1).
IMPORTANT! DO NOT crank the starting motor continuously for more than
30 seconds. Stop cranking the starter and allow the starter to cool for 2
minutes before engaging the starter again.
• As the engine starts, stop spraying the starting fluid and release
the ignition switch to the RUN (Figure 34, 3) position. Depress
the accelerator pedal enough to provide a smooth idle speed.
Figure 34
Figure 35
11. The engine oil pressure warning indicator light should go OFF
within 5 seconds after starting. If the light remains ON, turn the igni-
tion switch OFF (Figure 34, 4) immediately and check the oil level
or change to a lighter weight oil. Consult the engine manufacturer’s
manual for alternative oils for cold weather operation.
OT0680
1
3
2
4
OH1890
1