SkyTrak 6036 Operation Manual - Manual (Page 161)

General Maintenance
155 Model 6036
D. Chain Lubrication
(1000 Hour Intervals)
After inspection and before
being returned to service,
chains must be lubricated
with a quality chain lubricant (“LUBRIPLATE” Chain & Cable Fluid, “LPS3”
or equivalent).
The lubricant must penetrate the chain joint to prevent wear. Applying
lubricant to the external surfaces will prevent rust, but the chains should be
articulated to make sure the lubricant penetrates to the working surfaces
between the pins and links.
To prepare the chain for lubrication, the chain plates should be brushed with
a stiff brush or wire brush to clear the space between the plates so that
lubricant can penetrate to the working surfaces.
Lubricant may be applied with a narrow paint brush or directly poured on,
but the chain should be well flooded with lubricant and the boom should be
extended and retracted to be sure that the lubricant penetrates to the
working surfaces. All surplus lubricant should be wiped away from the
external surfaces. DO NOT use a solvent for this wiping operation.
Regular application of lubricant is necessary to make sure that all working
surfaces are adequately lubricated. In extremely dusty conditions, it may be
necessary to lubricate the chains more often.
Lubrication of chains on vehicles working consistently in extreme hot or cold
conditions requires special consideration. It is important that a reputable
lubrication specialist, an JLG Authorized Service Center (ASC) or the
vehicle distributor be consulted for guidance.
1000
OH2690 OA1510