SkyTrak 6036 Operation Manual - Manual (Page 41)

Operation
35 Model 6036
Instrument Cluster Light Test
(Figure 17)
Test the bulbs in the instrument cluster before starting the engine.
Turn the ignition switch to the RUN position, ALL nine lights in the
instrument cluster will come ON for a few seconds and then go out. Replace
any bulbs that DO NOT come ON during this test. These lights will warn the
operator if an abnormal condition should arise during operation and will also
inform the operator when the road lights are on high beam or the turn
signals are activated.
Figure 17
Refer to Figure 17 for position of corresponding lights:
• Alternator Charging Light (1)
• Park Brake Light (2)
• Engine Oil Pressure Light (3)
• Engine Coolant Temperature Light (4)
• Hydraulic Tank Temperature Light (5)
• Transmission Temperature Light (6)
• High Beam Light (7)
• Not Used (8)
• Turn Signal Light (9)
0000 00
P
OH1810
(1)
(2) (3)
(4) (5)
(6) (7)
(8) (9)