SkyTrak 6036 Operation Manual - Manual (Page 121)

General Maintenance
115 Model 6036
B. Oil And Filter Change
(First 50 Hours)
(250 Hour Intervals)
1. Operate the engine until warm (approximately 5 minutes).
2. Level the vehicle, ground the carriage, place the travel select lever
in (N) NEUTRAL, move neutral lock lever to NEUTRAL LOCK
position, engage the parking brake switch and shut off the engine.
3. Place receptacle under engine oil pan drain.
4. Remove drain plug from engine oil pan.
5. Allow oil to drain completely into a receptacle. Transfer the oil to a
container with a cover and label the container as used oil. Dispose
of the used oil at an approved recycling facility.
6. Unlock and open the left engine access door. Remove oil filter
(Figure 70, 1). A strap or chain filter wrench may be required.
Figure 70
7. Clean filter sealing surface. Make sure the o-ring seal from the filter
comes off the sealing surface.
50
250
OS0830
OH2670
OH2710
0724650
390
3102
OG0031
1