Philips LC1345 - Manual (Page 12)

12
Connecting AC Power Cord
5. Set Up
Note:
AC power cord must meet requirement of the country where you use the projector.
Confirm the AC plug type with the chart below and proper AC power cord must be used.
If supplied AC power cord does not match your AC outlet, contact your sales dealer.
To the power cord
Connector on your pro-
jector.
Projector side AC Outlet side
Ground
To the AC Outlet.
(120 V AC)
For Continental Europe For the U.S.A. and Canada
This projector uses nominal input voltages of 100-120 V or 200-240 V
AC. This projector automatically selects the correct input voltage.
It is designed to work with single-phase power systems having a
grounded neutral conductor. To reduce risk of electrical shock, do
not plug into any other type of power system.
Consult your authorized dealer or service station if you are not sure
of the type of power supply being in use.
Connect the projector with peripheral equipment before turning the
projector on. (Refer to pages 15 ~ 16 for connection.)
CAUTION
For safety, unplug AC power cord when the projector is not
used. When this projector is connected to the outlet with AC
power cord, it is in Stand-by Mode and consumes a little electric
power.
Connecting AC Power cord
Connect AC power cord (supplied) to the
projector. The AC outlet must be near the
projector and easily accessible.
For the U.K.
To the AC Outlet.
(200 - 240 V AC)
To the AC Outlet.
(200 - 240 V AC)