Philips DVD740VR98 - Manual (Page 31)

POWER
MARKER
SEARCH MODE DISPLAY SLOW ZOOM
OUTPUT SELECT
3
4 5 6
7 8 9
SPEED
TIMER SET
0 +10
2 1
VCR DVD
CLEAR
REPEAT
SETUP
TITLE RETURN MODE
CHANNEL/SKIP
A-B
AUDIO ANGLE SUBTITLE
REC/OTR REPEAT
DISC
MENU OK
PAUSE
REW FF
PLAY STOP
VCR/TV
MEMORY
STATUS/EXIT TIME SEARCH
Read and follow the steps below to record a television program
onto a video cassette tape. Before you begin, make sure the
DVD/VCR is in VCR mode. Press OUTPUT SELECT so the green
VIDEO light appears on the front of the DVD/VCR.
1 Turn on the TV and set it to channel 3 or 4,
whichever channel the CH3/CH4 switch on the back of the
DVD/VCR is set to. Or, if you connected the DVD/VCR to
the TV using audio and video cables, select the correct
audio and video in channel at the TV. Details are on page 11.
2 Insert a tape with its record tab intact into the cas-
sette compartment of the DVD/VCR. If tape playback
begins, press STOP C (p).
3 If the VCR/TV light appears on the front of the DVD/VCR,
go to step 4. If the VCR/TV light does not appear,
press VCR, then press VCR/TV once.
4 Press SPEED until the desired tape speed (SP or
SLP) appears briefly on the screen. (Details about tape
speed are on page 36.)
5 Press CHANNEL/SKIP j/i (p/o) or the
Number buttons to select the TV channel to be
recorded.
6 Press REC/OTR once to start recording. The red
REC light will appear on the front of the DVD/VCR.
7 To pause the recording, press PAUSE k once. The
red REC light will flash. To resume recording, press
REC/OTR or press PAUSE k again. The red REC
light will come on again.
8 To stop recording, press STOP C (p).
Recording Prevention
Video Cassettes have record tabs to ensure that recordings are
not accidentally erased.
1 To prevent recording, break off the tab with a
screwdriver.
2 To allow recording, cover the hole with clear tape.
Video Cassette Tape Recording 31
• If you press REC/OTR when there is
not a tape in the DVD/VCR, NO
CASSETTE will flash on the screen.
• If you press REC/OTR while a tape
without a record tab is in the
DVD/VCR, the DVD/VCR will eject
the tape and PROTECTED CAS-
SETTE CANNOT RECORD will flash
on the screen.
• Other recording options are on
pages 32-38.
• You can change the tape speed
during a recording, but some distor-
tion will appear on the tape.
• The DVD/VCR will record in a pre-
set volume.
Helpful Hints
1
Turn on the TV.
2 Insert a tape in the
DVD/VCR.
4
5
8
5
7
3
6
VCR
Remove the
tab to prevent
recording.
Cover the
hole to allow
recording.
DVD740VR 4/12/02 12:08 PM Page 31