Philips DVD740VR98 - Manual (Page 17)

POWER
MARKER
OUTPUT SELECT
3
4 5 6
TIMER SET
2 1
VCR DVD
CLEAR
REPEAT
SETUP
TITLE RETURN MODE
CHANNEL/SKIP
A-B
AUDIO ANGLE SUBTITLE
REC/OTR REPEAT
DISC
MENU OK
PAUSE
REW FF
PLAY STOP
VCR/TV
MEMORY
Disc Playback 17
• An “X” may appear at the top right
corner of the TV screen when you
try a feature. Either the feature is
not available on the Disc, or the
DVD/VCR cannot access the feature
at this time. This does not indicate
a problem with the DVD/VCR.
• If a Disc is dirty or scratched, the
pictures may appear distorted or
playback may stop. Remove the
Disc and turn off the DVD/VCR.
Disconnect the power cord, then
reconnect it. Clean the Disc, then
turn on the DVD/VCR again and
reinsert the Disc for playback.
• When the DVD or CD light appears
on the display panel, the Disc is
loaded completely and is ready for
playback.
• When you press OPEN/CLOSE or
PLAY (DVD) on the front of the
DVD/VCR when the power is off,
the DVD/VCR will turn on automati-
cally and will be in DVD mode.
Helpful Hints
● Before you begin, turn on the power of the TV, stereo receiv-
er and any other equipment connected to the DVD/VCR.
Make sure the TV and the stereo receiver (if applicable) are
set to the correct channel. Details are on pages 8-13.
1 Press POWER y y to turn on the DVD/VCR. “P-ON”
will appear briefly on the display panel. The DVD/VCR will
be in VCR mode.
2 Press OUTPUT SELECT so the red DVD light
appears on the front of the DVD/VCR. Then, press
DVD.
3 Press OPEN/CLOSE on the front of the DVD/VCR
to open the Disc tray.
4 Place a Disc into the tray.
Some DVDs are recorded on both sides. Make sure the
side you want to play is facing up. Or, if the DVD is
recorded on only one side, place the Disc in the tray with
the label facing up.
5 Press PLAY B (o). The tray will close automatically,
and playback will begin at the first Chapter or Track of the
Disc.
Or, you may press OPEN/CLOSE or press the tray toward
the DVD/VCR to close the tray; DVD playback will start
automatically.
If a DVD menu appears instead, see page 48.
With some Audio CDs, playback will not begin unless you
press PLAY B (o).
6 Press STOP C (p) to stop playback. If Disc playback
is stopped for more than five minutes, a screen saver will
appear. Details are on page 75.
1
2
6
Insert a Disc.
4
Remember, this DVD/VCR
will play only certain Discs.
See page six for details.
5
Press OPEN/CLOSE on
the DVD/VCR. 3
DVD AUDIO CD
DVD740VR 4/12/02 12:08 PM Page 17