B&B Electronics Zlinx ZP Series - Manual (Page 47)

Manual Documentation Number: ZP24D-250RM-SR-2508 43
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
D6 (DIO6 Configuration)
Command
The D6 command
is used to select/read the behavior
of the DIO6 line (pin 16).
Options include:
• RTS flow control
• Analog-to-digital
converter
• Digital input
• Digital output
D7 (DIO7 Configuration)
Command
The D7 command
is used to select/read the behavior
of the DIO7 line (pin 12).
Options include:
• CTS flow control
• Analog-to-digital
converter
• Digital input
• Digital output
D8 (DI8 Configuration)
Command
The D8 command
is used to select/read the behavior
of the DI8 line (pin 9).
This command enables configuring
the pin to function as a digital
input. This line is also used
with Pin Sleep.
AT Command: ATD6
Parameter Range:0 - 5
Parameter Configuration
0 Disabled
1 RTS Flow Control
2 n/a
3 DI
4 DO low
5 DO high
Default Parameter Value:0
Parameters 3-5 supported as of firmware
version 1.xA0
AT Command: ATD7
Parameter Range:0 - 5
Parameter Configuration
0 Disabled
1 CTS Flow Control
2 n/a
3 DI
4 DO low
5 DO high
Default Parameter Value:1
Parameters 3-5 supported as of firmware version
1.x.A0
AT Command: ATD8
Parameter Range:0 - 5 _ (1, 2, 4 & 5 n/a)
Parameter Configuration
0 Disabled
3 DI
Default Parameter Value:0
Minimum Firmware Version Required: 1.xA0