B&B Electronics Zlinx ZP Series - Manual (Page 38)

34 Manual Documentation Number: ZP24D-250RM-SR-2508
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
*Firmware version in which the command was first introduced (firmware versions are
numbered in hexadecimal notation.)
Commands-AT Command Options
AT_
Command Command_
Category
Name and Description
Parameter
Range
Default
CT
AT Command
Mode Options
Command Mode
Timeout.Set/Read the period of
inactivity (no valid commands
received) after which the RF
module automatically exits AT
Command Mode and returns to
Idle Mode.
2 - 0xFFFF
[x 100 ms]
0x64 (100d)
CN
AT Command
Mode Options
Exit Command Mode. Explicitly
exit the module from AT Command
Mode.
-- --
AC (v1.xA0*)
AT Command
Mode Options
Apply Changes. Explicitly apply
changes to queued parameter
value(s) and re-initialize module.
-- --
GT
AT Command
Mode Options
Guard Times. Set required period
of silence before and after the
Command Sequence Characters of
the AT Command Mode Sequence
(GT+ CC + GT). The period of
silence is used to prevent
inadvertent entrance into AT
Command Mode.
2 - 0x0CE4
[x 1 ms] 0x3E8
(1000d)
CC
AT Command
Mode Options
Command Sequence Character.
Set/Read the ASCII character
value to be used between Guard
Times of the AT Command Mode
Sequence (GT+CC+GT). The AT
Command Mode Sequence enters
the RF module into AT Command
Mode.
0 - 0xFF
0x2B
(‘+’ ASCII)
*Firmware version in which the command was first introduced (firmware versions are
numbered in hexadecimal notation.)
Command Descriptions
Command descriptions in this section are listed alphabetically. Command categories
are designated within "< >" symbols that follow each command title. Zlinx Radio
Modems expect parameter values in hexadecimal (designated by the "0x" prefix).
All modules operating within the same network should contain the same firmware
version.