B&B Electronics Zlinx ZP Series User Manual

Page 35

Manual Documentation Number: ZP24D-250RM-SR-2508

B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com

B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com

D6 (v1.x80*)

I/O Settings

DIO6 Configuration. Select/Read
settings for the DIO6 line (pin 16)
of the RF module. Options include
RTS flow control and I/O line
settings.

0 – 1

0 = Disabled
1 = RTS flow
control
2 = (n/a)
3 = DI
4 = DO low
5 = DO high

D5 (v1.x80*)

I/O Settings

DIO5 Configuration. Configure
settings for the DIO5 line (pin 15)
of the RF module. Options include
Associated LED indicator (blinks
when associated) and I/O line
settings.

0 – 1
0 = Disabled
1 = Associated
indicator
2 = ADC
3 = DI
4 = DO low
5 = DO high

D0 - D4
(v1.xA0*)

I/O Settings

(DIO4 -DIO4) Configuration.
Select/Read settings for the
following lines: AD0/DIO0 (pin
20), AD1/DIO1 (pin 19),
AD2/DIO2 (pin 18), AD3/DIO3
(pin 17), AD4/DIO4 (pin 11).
Options include: Analog-to-digital
converter, Digital Input and Digital
Output.

0 – 1
0 = Disabled
1 = (n/a)
2 = ADC
3 = DI
4 = DO low
5 = DO high

IU (v1.xA0*)

I/O Settings

I/O Output
Enable.Disables/Enables I/O data
received to be sent out UART.
The data is sent using an API
frame regardless of the current
AP parameter value.

0 – 1
0 = Disabled
1 = Enabled

IT (v1.xA0*)

I/O Settings

Samples before TX.Set/Read the
number of samples to collect
before transmitting data.
Maximum number of samples is
dependent upon the number of
enabled inputs.

1 - 0xFF

IS (v1.xA0*)

I/O Settings

Force Sample.Force a read of all
enabled inputs (DI or ADC). Data
is returned through the UART. If
no inputs are defined (DI or ADC),
this command will return error.

8-bit bitmap (each
bit represents the
level of an I/O line
setup as an
output)

IO (v1.xA0*)

I/O Settings

Digital Output Level.Set digital
output level to allow DIO lines that
are setup as outputs to be
changed through Command
Mode.

- -

IC (v1.xA0*)

I/O Settings

DIO Change
Detect.Enables/Disables the
monitoring of the change detect
feature on DIO lines 0-7. If a
change is detected, data is
transmitted with DIO data only.
Any samples queued and waiting
for transmission will be sent first.

0 - 0xFF [bitfield]

0
(disabled)