B&B Electronics Zlinx ZP Series User Manual
Page 25
Manual Documentation Number: ZP24D-250RM-SR-2508
21
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
to all PANs.
DH
Networking
{Addressing}
Destination Address High.
Set/Read the upper 32 bits of the
64-bit destination address. When
combined with DL, it defines the
destination address used for
transmission. To transmit using a
16-bit address, set DH parameter
to zero and DL less than 0xFFFF.
0x000000000000FFFF is the
broadcast address for the PAN.
0 - 0xFFFFFFFF
0
DL
Networking
{Addressing}
Destination Address Low.
Set/Read the lower 32 bits of the
64-bit destination address. When
combined with DH, DL defines the
destination address used for
transmission. To transmit using a
16-bit address, set DH parameter
to zero and DL less than 0xFFFF.
0x000000000000FFFF is the
broadcast address for the PAN.
0 - 0xFFFFFFFF
0
MY
Networking
{Addressing}
16-bit Source Address.Set/Read
the RF module 16-bit source
address. Set MY = 0xFFFF to
disable reception of packets with
16-bit addresses. 64-bit source
address (serial number) and
broadcast address
(0x000000000000FFFF) is
always enabled.
0 - 0xFFFF
0
SH
Networking
{Addressing}
Serial Number High. Read high
32 bits of the RF module's unique
IEEE 64-bit address. 64-bit
source address is always
enabled.
0 - 0xFFFFFFFF
[read-only]
Factory-set
SL
Networking
{Addressing}
Serial Number Low. Read low
32 bits of the RF module's unique
IEEE 64-bit address. 64-bit
source address is always
enabled.
0 - 0xFFFFFFFF
[read-only] Factory-set
RR ( v1.xA0*)
Networking
{Addressing}
Retries. Set/Read the maximum
number of retries the module will
execute in addition to the 3 retries
provided by the 802.15.4 MAC.
For each retry, the 802.15.4 MAC
can execute up to 3 retries.
0 - 6
0
RN
Networking
{Addressing}
Random Delay Slots. Set/Read
the minimum value of the back-off
exponent in the CSMA-CA
algorithm that is used for collision
avoidance. If RN = 0, collision
avoidance is disabled during the
first iteration of the algorithm
(802.15.4 - macMinBE).
0 - 3 [exponent]
0