Boss Audio Systems DR-670 - Manual (Page 77)

77
Chapter 7 Customizing Your Setup (Utility Mode)
Chapter
7
Assigning Functions to
the Foot Switches
Settings for the functions controlled with the
foot switches 1 and 2.
fig.07-05
STRT:
Used for starting the pattern or song from
the beginning and stopping the pattern or
song.
Same operations achieved by pressing
[START] and [STOP/CONT].
FILL:
Switches to the fill pattern.
Same operation achieved by pressing [FILL].
CONT:
Controls Continue Start/Stop.
Same operation achieved by pressing
[STOP/CONT].
RSET:
Resets the song or pattern (jumps to the
beginning).
Same operation achieved by holding down
[SHIFT] and pressing [
].
REC:
Starts Realtime Recording.
Same operation achieved by holding down
[REC] and pressing [START].
* This is enabled in Pattern Edit mode and Song
Edit mode.
CHAS:
When the DPP function is off, this function
selects the pattern with the number one
greater than the currently selected pattern
number. If Pattern Number 400 is currently
selected, then Pattern Number 1 is the next
pattern selected.
When the DPP function is on, this function
selects the pad with the number one higher
than the currently selected pad. If Pad
Number 16 is currently selected, then Pad
Number 1 is selected next.
* This is enabled in Pattern Play mode and Song
Edit mode.
PD 1–PD16, PD G, PD D, PD A, PD E:
Performs the same operations achieved by
pressing the pads with the specified
numbers (1–16, G, D, A, E).
Functions according to the currently selected
pad function (DRUM A, DRUM B, BASS,
DPP).
Changing the Roll Settings
(Roll Type)
Sets the note length for rolls.
fig.07-05a
fig.07-05b
Foot Switch 1
Foot Switch 2
(32nd note)
(16th note triplets)
(16th note)
(8th note triplets)
(8th note)