Boss Audio Systems DR-670 - Manual (Page 67)

67
Chapter 4 Recording and Editing Songs (Song Edit Mode)
Chapter
4
■ Starting Realtime
Recording Within a Song
You can start Realtime Recording from a point
other than the beginning of the song.
This is convenient when you want to insert
patterns in lengthy songs.
1. With the performance stopped, press [ ]
[ ] to specify the measure where
recording is to begin.
* When recording two-measure patterns, you
cannot specify the second measure of each
pattern.
fig.04-08b
2. Hold down [REC] and press [START].
Recording begins from the currently selected
measure.
The tempo indicator flashes on each beat.
3. When you reach the measure before the one
you want to substitute, select the next
pattern to be recorded.
Turn the TEMPO/VALUE dial to select the
pattern number.
* You can also select the pattern by inputting the
pattern number with the numeric keys and
pressing [
].
4. When the replacement pattern is recorded,
press [STOP/CONT] to end recording.
* If no pattern number is entered as the
replacement pattern, then the pattern already
recorded is played.
■ Adding Patterns at the
End of a Song
You can start Realtime Recording at the end of a
recorded song to add more patterns to the song.
1. With the performance stopped, hold down
[SHIFT] and press [ ].
This lets you jump to the measure following
the last measure of the song.
2. Select a pattern to add.
Turn the TEMPO/VALUE dial to select the
pattern number.
* You can also select the pattern by inputting the
pattern number with the numeric keys and
pressing [
].
3. Hold down [REC] and press [START].
Recording begins from the measure number
following the last measure of the song, while
the additional pattern you selected starts to
play.
The tempo indicator flashes on each beat.
* The same pattern continues to be recorded until
the next pattern is selected.
4. Select the next pattern to be recorded.
5. Repeat Step 4 as needed to record
additional patterns.
* When Pattern 250 is reached, the message “PTN
FULL” appears, and recording is ended
automatically.
6. Press [STOP/CONT] to stop the recording.
Measures You Can Specify
Pattern 1 Pattern 2 Pattern 3 Pattern 4
measure