Boss Audio Systems DR-670 - Manual (Page 70)

70
Chapter 4 Recording and Editing Songs (Song Edit Mode)
Removing Unneeded Song
(Song Clear)
This erases content of the cullently selected
Song.
1. Hold down [SHIFT] and press [3] (CLEAR).
* Continue to hold down [SHIFT].
fig.04-12
2. If you are sure you want to clear the song,
while still holding down [SHIFT], press
[
].
The song is erased, and when it is finished
the display will indicate “DONE.”
3. When the song is cleared, release [SHIFT].
* If the selected pattern has not been recorded yet
(has no data recorded to it), “DATA EMPT” is
displayed without the clear being executed. If this
occurs, first release [SHIFT] and carry out the
procedure again from the beginning.
* To cancel the operation, release [SHIFT].
Copying Song
This copies content of the cullently selected Song
to other Song.
* Note that when a song is recorded to a copy
destination, the data that was in the copy
destination is discarded.
1. Hold down [SHIFT] and press [4] (COPY).
* Continue to hold down [SHIFT].
fig.04-13
2. Select the copy-destination song number.
Hold down [SHIFT] and rotate the TEMPO/
VALUE dial to select the song, then press
[
] to confirm the selection
* You can also input the song number by pressing
the numeric keys, and select the song by pressing
[
].
fig.04-14
3. If you are sure you want to copy the song,
hold down [SHIFT] and press
[
].
The song is copied, and when it is finished
the display will indicate “DONE.”
4. When the copy is completed, release
[SHIFT].
* If the copied song has not been recorded yet (has
no data recorded to it), “DATA EMPT” is
displayed without the copy being executed. If this
occurs, first release [SHIFT] and carry out the
procedure again from the beginning.
* To cancel the operation, release [SHIFT].
Copy source Copy destination