Brother PE 400D - Manual (Page 21)

18
2
1
5. Guide the thread through the small hole in the side of the bob-
bin from the inside. Align the groove in the bobbin with the
spring on the shaft and place the bobbin on the bobbin winder
shaft. While holding the thread end, push the bobbin winder
shaft to the right.
1 Spring on the shaft
2 Groove of the bobbin
6. Set the speed to minimum.
8. Set the speed to maximum.
9. Press the "START/STOP" button. The bobbin will stop spin-
ning when bobbin winding is finished.
10. When the bobbin stops spinning, press the "START/STOP"
button to stop the sewing machine.
2
1
7. While holding the thread end, press the “START/STOP” but-
ton. Wind the thread a few times around the bobbin and press
the “START/STOP” button again.
Trim the excess thread from the top of the bobbin after the
machine stops.
11. Push the bobbin shaft to the left. Remove the bobbin.