Bosch HBN 5405.0 A - Manual (Page 25)

25
The rear wall, top and side walls of the oven are
coated with selfĆcleaning enamel. The surfaces clean
themselves while the oven is in operation. Large
splashes may only disappear after the oven has been
used several times.
Never use oven cleaner on selfĆcleaning surfaces.
If the selfĆcleaning surfaces of the oven are no longer
cleaning themselves sufficiently, they can be
regenerated using the cleaning function.
Should the enamel become slightly stained, this will
not affect its selfĆcleaning properties.
Use hot soapy water or a vinegar solution.
It is best to use oven cleaner if the oven is very dirty.
Only use oven cleaner in a cold oven.
Never use oven cleaner on the selfĆcleaning surfaces
of the oven.
Note:
Enamel is baked on at very high temperatures. This
can cause some slight colour variation. This is normal
and does not affect the function. Do not use coarse
scouring pads or strong cleaning agents to remove
such discolorations.
The edges of thin trays cannot be completely
enamelled. As a result, these edges can be rough.
AntiĆcorrosion protection is guaranteed.
It is best to clean the glass cover with washingĆup
liquid.
The cleaning function is a regeneration program. If the
selfĆcleaning components of the oven are no longer
cleaning themselves sufficiently, they can be
regenerated using this function. They are then fully
operational again.
Remove accessories and ovenware from the oven.
Cleaning the catalytic
surfaces of the oven
Cleaning the oven floor
Cleaning the glass cover
for the oven light
Cleaning function