Brother MFC-5860CN - Manual (Page 65)

Dialling and storing numbers
55
8
Changing Speed-Dial names
or numbers
8
If you try to store a Speed-Dial number where
a number has already been stored, the LCD
will show the name or number that has been
stored there, and will ask you to do one of the
following:
„ Press 1 to change the stored number.
#05:Mike
1.Change
2.Exit
„ Press 2 to exit without making a change.
If you chose 1, you will be able to change the
stored number and name, or enter a new one.
Follow the instructions below:
a
Enter a new number. Press OK.
b
Enter a new name. Press OK.
To change a character, use d or c to position
the cursor under the character you want to
change, then press Clear/Back.
Re-enter the character.
Setting up groups for
broadcasting
8
If you regularly want to send the same fax
message to many fax numbers you can set
up a Group. Groups are stored on a
Speed-Dial number. Each group uses up a
Speed-Dial location. You can then send the
fax message to all the numbers stored in a
group just by entering a Speed-Dial number,
and then pressing Mono Start.
Before you can add numbers to a Group, you
need to store them as Speed-Dial numbers.
You can have up to six small Groups, or you
can assign up to 99 numbers to one large
Group.
a
Press Menu, 2, 3, 2.
Set Quick-Dial
2.Setup Groups
b
Use the dial pad to enter the two-digit
Speed-Dial number where you want to
store the Group.
Press OK.
Note
Please select a Speed-Dial number that
has not already been used to store a
number.
c
Use the dial pad to enter a Group
number (1 to 6).
Press OK.
Setup Groups
Setup Group:G01
d
To add Speed-Dial numbers follow the
instructions below:
For example, for Speed-Dial numbers
05 and 09.
Press Search/Speed Dial, 05,
Search/Speed Dial, 09.
The LCD shows: #05 #09.
Setup Groups
G01: #05 #09