Brother MFC-5860CN - Manual (Page 130)

120
Note
If the protective yellow caps come off
when you open the bag, the cartridge will
not be damaged.
e
Each colour has its own correct position.
Insert the ink cartridge in the direction of
the arrow on the label.
f
Lift each lock release lever and push it
until it clicks, and then close the ink
cartridge cover.
g
The machine will automatically reset the
ink dot counter.
Note
If the LCD shows No Cartridge after
you install the ink cartridges, check that
the ink cartridges are installed properly.
WARNING
• If you replaced an ink cartridge before
the LCD shows Near Empty or
Ink Empty
, the LCD will ask you to
verify that it was a brand new one. (For
example, Did You Change Blck?)
For each new cartridge you installed,
press 1 (Yes) to automatically reset the
ink dot counter for that colour. If the ink
cartridge you installed is not a brand
new one, be sure to press 2 (No).
• If ink gets in your eyes, wash them out
with water at once and call a doctor if
you are concerned.
CAUTION
DO NOT take out ink cartridges if you do
not need to replace them. If you do so, it
may reduce the ink quantity and the
machine will not know the quantity of ink left
in the cartridge.
DO NOT touch the cartridge insertion slots.
If you do so, the ink may stain your skin.
If ink stains your skin or clothing, wash with
soap or detergent at once.
If you mix the colours by installing an ink
cartridge in the wrong position, clean the
print head several times after correcting the
cartridge installation. (See page 123.)
Once you open an ink cartridge, install it in
the machine and use it up within six months
of installation. Use unopened ink cartridges
by the expiration date written on the
cartridge package.
M
brother
XXXX