Brother MFC-5860CN - Manual (Page 40)

30
5
Entering Fax mode
5
To enter fax mode, press (Fax), and
the key will glow green.
Faxing from the ADF
5
a
Make sure you are in Fax mode .
b
Put the document face up in the ADF.
c
Dial the fax number.
d
Press Mono Start or Colour Start.
The machine starts scanning the
document.
Note
• To cancel, press Stop/Exit.
• If the memory is full, the document will be
sent in real time.
Faxing from the scanner glass
5
You can use the scanner glass to fax pages
of a book one at a time. The documents can
be up to letter or A4 size.
You cannot send multiple pages for colour faxes.
Note
Since you can only scan one page at a
time, it is easier to use the ADF if you are
sending a multiple page document.
a
Make sure you are in Fax mode .
b
Load your document on the scanner glass.
c
Dial the fax number.
d
Press Mono Start or Colour Start.
„ If you press Mono Start, the
machine starts scanning the first
page. Go to step e.
„ If you press Colour Start, the
machine starts scanning and
sending the document.
e
Do one of the following:
„ To send a single page, press 2 to
choose No. (or press Mono Start
again).
The machine starts sending the
document.
„ To send more than one page, press
1 to choose Yes and go to step f.
f
Put the next page on the scanner glass.
Press OK.
The machine starts scanning the page.
(Repeat step e and step f for each
additional page.)
Note
If the memory is full and you are faxing a
single page, it will be sent in real time.
Sending a fax
5