Philips TensRelief 12 selbstklebende Elektroden - Manual (Page 39)

Problem Possible cause Solution
The ‘no
connection
symbol’
is on the
screen (see
chapter
‘Signals on
the device’).
There is no
connection
because the
TENS units
are switched
off.
Check if the TENS units are switched
on. The treatment status indicator
flashes green when the TENS units are
switched on and in standby. If the TENS
units are switched off, press the on/off
button to switch them on.
There is no
connection
because
battery of the
TENS units is
empty.
Charge the TENS units (see chapter
‘Preparing for use’).
The TENS
units
overheated
inside. If this
is the case,
the treatment
status indicator
flashes red.
Detach the TENS units and let them
cool down. As soon as they have
cooled down sufficiently, you can
reattach them to the electrodes
and press the on/off button on the
TENS units to resume treatment. The
TENS units may become warm on
the outside during treatment, but the
temperature never becomes so high
that there is any risk of damage or
injury.
The remote
control is too
far from the
TENS units.
Bring the remote control closer to the
TENS units.
The TENS
units may be
broken.
Contact the Philips Consumer Care
Centre.
English 39