Philips TensRelief 12 selbstklebende Elektroden - Manual (Page 32)

, The intensity level is shown in numbers above
the left intensity button. The intensity level is
also shown by the intensity level bar on the left
side of the screen.
, Hold down the + side of the intensity button on
the right side of the remote control to increase
the intensity of the extension channel. This starts
the pulse to the third and the fourth electrode.
, The intensity level is shown in numbers above
the right intensity button. The intensity level is
also shown by the intensity level bar on the right
side of the screen.
2 To end the treatment of one or both channels
before the set treatment time has elapsed or if
you set the treatment duration to ‘continuous’,
hold down the - side of the intensity button for
3 seconds to make the intensity drop to 0 mA.
When the intensity level is 0 mA, no pulse is
emitted by the TENS units.
Note: Because you can operate the two channels
independently, you can stop treatment on one channel
while you continue treatment on the other.
Note: You can also end the treatment by pressing the
on/off button on the TENS units. In that case, treatment
on both channels stops immediately.
English 32