Philips TensRelief 12 selbstklebende Elektroden - Manual (Page 30)

Note: The same duration applies to both channels of
the Wireless TENS Pro (PR3094).
starting and stopping a treatment (PR3093)
To start a treatment, you first have to switch on the
TENS units with the on/off button and then you
press the + side of the intensity button to increase
the intensity.
1 Press + side of the intensity button to set the
intensity. The intensity always starts to increase
from 0 mA. The treatment starts and the timer
starts to count down as soon as the intensity
is higher than 0 mA. The higher the intensity,
the stronger the pulse in the area to which the
electrodes are attached.
, Hold down the + side of the intensity button
to increase the intensity constantly and slowly.
Release the intensity button when you feel you
have found the right level of stimulation.
Note: For Conventional TENS and Frequency-modulated
TENS, you should clearly feel the stimulation, but this
should not be an unpleasant sensation and should not
be painful.
Note: For Burst TENS, you should feel the stimulation
strongly, which generally gives a sharper sensation and can
feel somewhat unpleasant. It is also advised to adjust the
intensity to a level that produces visible muscle contractions
in the stimulation area. These contractions are not harmful.
If you find the contractions too uncomfortable, you can
decrease the intensity, choose a different program or move
the electrodes to a different place.
, The intensity level is shown in numbers above
the intensity button. The intensity ranges from 0
mA to 60 mA. The intensity level is shown by the
intensity level bar on the right side of the screen.
The higher the bar, the higher the intensity.
English 30