Using the cycle sewing function – Brother LK3-B448E User Manual
Page 66
59
13. Using the cycle sewing function
LK3-B448E MARK
II
/BA-16
S E L E C T
PROGRAM NO.
R E S E T
COUNTER
X-SCALE
Y-SCALE
SPEED
P
T E S T
BOBBIN.WIND
P4
P3
P1
P2
POWER
B430E Series
t
!0
!1
e
w
!2
r
y
u
i
q
13. Using the cycle sewing function
What is the cycle sewing function?
The cycle sewing function lets you program up to four patterns for cycle sewing of patterns in a predeter mined
order.
Recording a cycle sewing program
1. Set DIP switch
q
-3 to ON, and then record the pat-
terns which you would like to use for cycle sewing.
(Refer to “12-4. Using user programs”.)
* Cycle sewing cannot be performed using patterns (P1 to P16)
which have not had a user program assigned.
2. Set the memo-03 switch to ON. (Refer to page 45
for how to do this.)
3. While pressing the TEST switch
w
, press the SE-
LECT switch
e
.
* All of the menu indicators (
r
to
i
) will illuminate and the mode
will switch to recording mode.
4. Press the P1 switch
o
.
• “Pc 1” will appear in the display window
!00
to indi-
cate that cycle sewing program No. 1 is being re-
corded.
* Programs P2, P3 and P4 switches can also be used for program-
ming.
5. Press the SELECT switch e.
*The PROGRAM No. indicator
r
will illuminate and “1- -” will appear in the display window
!0
.
6. Press the DISPLAY SET switches
!1
to select the number for the user program that you would like to
record.
7. Press the SELECT switch
e
.
*“2- -” will appear in the display window
!0
.
8. Press the DISPLAY SET switches
!11
to select the number for the user program that you would like to record.
9. Repeat steps 5. and 6. to record all programs which you would like to include for cycle sewing.
* After “9- -” is displayed, “A- -”, “b- -”, “c- -”, “d- -”, “E- -” and “F- -” will be displayed in that order so that up to the 15th pattern can be recorded.
* If you would like to return to a previous number during the recording procedure, press the P1 switch so that “Pc 1” is displayed, and then
return to step 4.
10. Press the TEST switch
w
.
• This completes the setting of cycle sewing program No. 1.
* The menu indicators (
r
to
i
) will all illuminate and “c1-1” will appear in the display window
!0
to indicate that the cycle sewing program
No.1 is currently selected.
o