Brother HL-1040 - Manual (Page 202)

- 28 -
High Temperature
Warning
After you have just used the printer,
some internal parts of the printer are
extremely hot. When you open the top
cover of the printer, never touch the
shaded parts shown in the following
illustration.
2 Remove the toner cartridge from the drum
unit and keep it in a safe place.
✒ Note
Discard the used drum unit according to local
regulations. If you are not sure of them, consult
your local dealer/retailer. Be sure to seal up the
drum unit tightly so that toner powder does not
spill out of the unit. Do not discard used drum
units together with domestic rubbish.
It is recommended to put the drum unit on a
piece of disposable paper or cloth in case of
accidental toner spill or scatter.
3 Unpack the drum unit and gently shake it
five or six times horizontally.
!
Caution
Only unpack a drum unit immediately
before installing it into the printer. If an
unpacked drum unit is subjected to
excessive direct sunlight or room light,
the unit may be damaged.
Handle the toner cartridge and the drum
unit carefully as it contains toner. If
toner scatters and your hands or clothes
get dirty, wipe or wash it off with cold
water immediately.
!
Caution
Do not remove the starter sheet.