Using the polling function, Using the polling function" o, Ge 36 – Sharp MX-M232D User Manual
Page 38: Select "sending options" with the [ ] or [ ] key, Press the [ok] key, Select "polling" with the [ ] or [ ] key, Press the [start] key
36
ADVANCED TRANSMISSION METHODS
USING THE POLLING FUNCTION
When used in conjunction with the timer transmission function (page 33), only one polling job can be stored.
1
In Fax mode, press the [SPECIAL
FUNCTION] key.
When the [SPECIAL
FUNCTION] key is pressed, the
special function menu appears.
(To select fax mode, see step 1
on page 17.)
2
Select "SENDING OPTIONS" with the
[
] or [
] key.
3
Press the [OK] key.
4
Select "POLLING" with the [
] or [
]
key.
5
Press the [OK] key.
6
Enter the fax number of the other
machine with the numeric keys, press
a Rapid key, or specify a Speed Dial
number (a group key cannot be used).
To clear a mistake when
entering a full number with the
numeric keys, press the [C] key
to clear one digit at a time.
A destination selected with a Rapid key or Speed Dial
number is indicated by an icon and a number. To clear
an entry, press the [C] key.
7
Press the [OK] key.
8
Press the [START] key.
"Polling reservation has been
set." appears in the screen.
After communicating with the
other machine, your machine
prints the received fax.
If the other machine is using polling security (see "Restricting polling access (polling security)" on page 40), your
fax number (sender's number) must be programmed in the system settings (see "OWN PASSCODE SET" on
page 101) and your number must also be programmed in the other machine.
Note
EXPOSURE
COLOUR MODE
PAPER SE
RESOLUT
COPY
SCAN
SPECIAL
FUNCTION
LINE
DATA
DATA
ON LINE
PQ
ACC
LEX SCAN
LEX SCAN
DED COPY
SPECIAL FUNCTION
FAX PRINT HOLD
TIMER MODE
SENDING OPTIONS
GHI
PQRS
BACK
OK
SENDING OPTIONS
POLLING
SERIAL POLLING
SUB ADDRESS TX
OK
WXYZ
36
37
38
31
32
33
26
27
28
A
B
C
F
G
H
OK
MNO
WXYZ
@.-_
AD-END
To cancel the operation
During communication: Cancel as explained in "Cancelling a fax transmission" on page 25.
While the job is stored: Cancel as explained in "Cancelling a stored transmission job" on page 26.
Note