Nokia E63 - Manual (Page 66)

• Homepage — Enter the web address of the page you
want to display as the home page when you use this
access point.
4. After defining the settings, select Options > Advanced
settings to define the advanced settings or Back to save
the settings and exit.
Advanced internet access point
settings for packet data (GPRS)
Select Menu > Tools > Settings > Connection > Access
points .
After setting up a basic internet access point for packet data
(GPRS), select Options > Advanced settings and define the
following advanced settings:
•
Network type — Select IPv4 or IPv6 as the internet
protocol type. The internet protocol defines how data is
transferred to and from your device.
• Phone IP address — Enter the IP address of your device.
Select Automatic to have the network provide the device
IP address. This setting is shown only if you select
Network type > IPv4 .
• DNS address — Select Primary DNS address and
Secondary DNS address and enter their IP addresses, if
required by your service provider. Otherwise, the name
server addresses are provided automatically.
• Proxy server address — Enter the address of the proxy
server. Proxy servers are intermediate servers used by
some service providers between a browsing service and
its users. These servers may provide additional security
and speed up access to the service.
Set up an access point for WLAN
manually
1. Select Menu > Tools > Settings > Connection >
Access points .
2. Select Options > New access point to create a new
access point, or select an existing access point from the
list and then Options > Duplicate access point to use
the access point as a basis for the new one.
3. Define the following settings.
• Connection name — Enter a descriptive name for the
connection.
• Data bearer — Select Wireless LAN .
• WLAN network name — To enter the service set
identifier (SSID), that is, the name that identifies the
specific WLAN, select Enter manually . To select the
network from the WLANs in range, select Search for
networks .
• Network status — Select Hidden if the network you
are connecting to is hidden or Public if it is not hidden.
• WLAN network mode — If you select
Infrastructure , devices can communicate with each
other and with wired LAN devices through a WLAN
access point. If you select Ad-hoc , devices can send and
receive data directly with each other, and no WLAN
access point is needed.
• WLAN security mode — You must select the same
security mode that is used in the WLAN access point. If
you select WEP (wired equivalent privacy), 802.1x or
WPA/WPA2 (Wi-Fi protected access), you must also
configure the relevant additional settings.
© 2010 Nokia. All rights reserved. 66