Toshiba Portege S100 - Manual (Page 126)

7-4 User’s Manual
HW Setup
To change the boot drive, follow the steps below.
1. Hold down F12 and boot the computer.
2. The following menu will be displayed with the following icons:
Built-in HDD, Ultra Slim Bay HDD, CD-ROM, FDD (or SD memory
card), Network (LAN) boot.
3. Use the left/right cursor keys to highlight the boot device you want and
press Enter.
HDD Priority Options
If more than one HDD is installed in the computer, this option lets you set
the priority for HDD detection. If the first detected HDD has a boot
command, the system will boot from the HDD.
A bar will appear only under the selected device.
■ If a supervisor password is set only, it is the following.
■ The menu above appear when you use the user password to start
the computer (able to run HW Setup).
■ The menu above does not appear when you use the user password
to start the computer (unable to run HW Setup).
■ If the supervisor and user password are set, it is the following.
■ The menu above appear when you use the supervisor and user
password to start the computer (able to run HW Setup).
■ The menu above does not appear when you use the user password
to start the computer (unable to run HW Setup).
■ The menu above appear when you use the supervisor password to
start the computer (unable to run HW Setup).
■ The selection method above does not change the boot priority settings
in HW Setup.
■ If you press a key other than one of those above or if the selected
device is not installed, the system will boot according to the current
setting in HW Setup.
Built-in HDD −>
2nd HDD (Default)
The computer will look for the Built-in HDD first,
next the 2nd HDD (Default).
2nd HDD −>
Built-in HDD
The computer will look for the 2nd HDD first,
next the Built-in HDD.