Toshiba Tecra S2 - Manual (Page 89)

TECRA A3/S2 4-10
Operating Basics
Wireless communication switch
You can enable or disable wireless LAN function, with the on/off switch. No
transmissions are sent or received when the switch is off. Slide the switch
forward to turn it on and backward to turn it off.
Wireless communication LED
The LED indicates the status of the wireless communication functions.
Changing Slim Select Bay modules
This section explains how to change modules in the Slim Select Bay. The
illustrations below show replacement of the DVD-ROM drive with the Slim
Select Bay HDD adaptor. Therefore, the text refers to those modules.
However, the procedures are the same for any of the modules: CD-ROM
drive, DVD-ROM drive, DVD-ROM&CD-R/RW drive, DVD±R/±RW drive,
DVD Super Multi drive, HDD adaptor, or weight saver.
Removing a module
Remove the DVD-ROM drive as described below.
1. You can confirm that the disks are not operating with indicators. If all
indicators are off, it means that no disks are operating currently.
2. Turn the computer upside down.
3. Remove the lock screw near the icon securing the Slim Select Bay.
4. Make sure the screw in the Slim Select Bay lock is set in the hole for the
unlock position.
Turn the switch off in airplanes and hospitals. Check the LED. It stops
glowing when the wireless communication function is off.
LED status Indication
LED off Wireless communication switch is set to off
LED glows Wireless communication switch is on
The Slim Select Bay is available depening on the model you purchased.
To avoid injury, do not put your hand into the Slim Select Bay slot.
The TOSHIBA Bay Service is preinstalled to support hot swapping under
Windows.
Wait for all disk indicators to go out before you turn over the computer and
do not lay the computer down gently. Shock can damage the Hard disk drive
or other components.