Toshiba Tecra S2 - Manual (Page 162)

TECRA A3/S2 9-14
Troubleshooting
Pointing device
If you are using a USB mouse, also refer to the USB section in this chapter
and to your mouse documentation.
TouchPad
USB mouse
Problem Procedure
On-screen pointer does
not respond to Pad
operation.
The system might be busy. If the pointer is shaped
as an hourglass, wait for it to resume its normal
shape and try again to move it. You may also press
Fn + F9 to enable the Touch Pad and then try again
to move it.
Double-tapping does
not work.
Try changing the double-click speed setting in the
mouse control utility.
1. Open the Control Panel, select the Mouse
icon and press Enter.
2. Click the Buttons tab.
3. Set the double-click speed as instructed and
click OK.
The mouse pointer
moves too fast or too
slow.
Try changing the speed setting in the mouse
control utility.
1. Open the Control Panel, select the Mouse
icon and press Enter.
2. Click the Pointer Options tab.
3. Set the speed as instructed and click OK.
If problems persist, contact your dealer.
Problem Procedure
On-screen pointer does
not respond to Pad
operation.
The system might be busy. If the pointer is shaped
as an hourglass, wait for it to resume its normal
shape and try again to move it.
Make sure the mouse is properly connected to the
USB port.
Double-tapping does
not work.
Try changing the double-click speed setting in the
mouse control utility.
1. Open the Control Panel, select the Mouse
icon and press Enter.
2. Click the Buttons tab.
3. Set the double-click speed as instructed and
click OK.