Search, Other operations, Index search – Toshiba DVR18 User Manual
Page 87: Time search
EN
In
troducti
on
Connecti
o
ns
Bas
ic Setup
P
layback
Ed
iti
n
g
V
CR Fu
ncti
on
s
Ot
hers
Fu
nc
ti
on
Set
u
p
Recordi
n
g
87
Search
Index Search
1
Press [VCR].
2
Press [SEARCH] so that the index
search menu appears.
3
Enter the number of recordings you
want to skip using
[the Number buttons] within 30
seconds.
4
Press [FWD
f] or [REV r] to start
index search.
If you want to go in the forward direction, press
[FWD
f].
If you want to go in the reverse direction, press
[REV
r].
After index search, the VCR will play back the
tape automatically.
Note
• This function is not available during recording.
• Every time a tape is recorded, an index mark is
written on the tape.
• You can make the index mark up to 20.
Time Search
This feature allows you to go to a specific point on a
tape by entering the exact amount of time you want to
skip in order to reach the point.
1
Press [VCR].
2
Press [SEARCH] repeatedly until the
time search menu appears.
3
Enter your desired time to skip using
[the Number buttons] within 30
seconds.
4
Press [FWD
f] or [REV r] to start
time search.
If you want to go in the forward direction, press
[FWD
f].
If you want to go in the reverse direction, press
[REV
r].
After time search, the unit will play back the tape
automatically.
Note
• This function is not available during recording.
• Press [STOP
S] to stop the search.
• If the tape reaches the end during the search, this
unit will cancel it and rewind the tape.
• You can set the time up to 9:59.
Other Operations
Press [VCR] first.
To cue or review picture during playback
(Picture Search):
Press [FWD
f] or [REV r] during playback.
Press it again and the unit will search in super high
speed (in the LP mode only).
To freeze the picture on TV screen during
playback (Still mode):
Press [PAUSE
p]. Each time you press the button,
the picture will be forwarded frame by frame.
If the picture begins to vibrate vertically during the still
mode, stabilise the picture by pressing the
[PROG.
/ ].
If the picture is distorted or rolling vertically, adjust the
vertical hold control on your TV, if equipped.
To reset the tape counter:
Press [CLEAR].
To play back in slow forward motion:
During playback, press [PAUSE
p], then press
[FWD
f].
If the noise bars appear on the TV screen, you can
reduce it by pressing [PROG.
/ ]. Slow reverse
is not available in VCR mode.
Note
• Still / Slow / Pause mode will be automatically
cancelled after 5 minutes to prevent damage to the
tape and the video head.
• To return to normal play back from the Picture
Search / Still / Slow mode, press [PLAY
P].
VCR
VCR
VCR
VCR
VCR
VCR
E9NG1BD_EN.book Page 87 Monday, April 7, 2008 5:54 PM