beautypg.com

Basic setup, Initial setting, Channel setting – Toshiba DVR18 User Manual

Page 23: Auto tuning (dvb & analog)

background image

23

EN

In

trod
uct
ion

Co
nn
ect
io

n

s

Basic Setup

Pl

ayback

Ed
iti

n

g

V

CR Fu

ncti

on
s

O

th

ers

Fu
nc
ti

on
Set

u

p

Recordi

n

g

Initial Setting

When you turn on this unit for the first time, you need
to follow these steps.

1

Press [

ON / STANDBY].

2

Turn the TV on. Select the input to
which the unit is connected.

3

Select your desired channel preset
type using [

U / D]. Then press

[ENTER / OK].

The unit will start getting channels available in
your area.

Digital tuning:
Only the DVB channels receivable in your area are
automatically scanned and memorised.
Digital & Analog tuning:
Both analogue and DVB channels receivable in your
area are scanned and memorised automatically.
Analog tuning:
Only the analogue channels receivable in your area
are automatically scanned and memorised.
• If no channel has been memorised, the antenna

confirmation display will appear. Press
[ENTER / OK] to start auto scanning again or press
[RETURN / BACK] to cancel the initial setting.

4

After finishing channel setting,
“Clock Setting” will appear. Then
press [ENTER / OK].

5

Follow to the step 5 on page 33 in
“Manual Clock Setting”.

Channel Setting

You can retune this unit or edit the channel setting by
the following methods.

Auto Tuning (DVB & ANALOG)

Programme the tuner to scan both analogue and DVB
channels you can receive in your area.

1

In stop mode, press [SETUP]. Select
“General Setting” using [

U / D],

then press [ENTER / OK].

“General Setting” menu will appear.

2

Select “Channel” using [

U / D], then

press [ENTER / OK].

3

Select “Auto Tuning (DVB &
ANALOG)” using [

U / D], then press

[ENTER / OK].

The unit will start storing channels available in
your area.

Wait for several minutes to finish channel storing.
• Analogue channels will be stored in channel

901-999 after it is scanned by this unit.

4

Press [SETUP] to exit.

You can select only the channels memorised in
this unit by using [PROG.

/ ].

To cancel auto tuning
Press [RETURN / BACK] or [SETUP] during
scanning.

Note

• The selection will be affected by how you receive TV

channels in your local area.

• If the auto tuning is cancelled during scanning,

some channels not yet tuned may not be received.

• You cannot change the channel when this unit is in

any recording mode (normal recording, One-touch
Timer Recording or timer recording).

Basic Setup

Initial Setting

Auto Tuning

Make sure the antenna is
connected to “ANTENNA IN” jack.

Digital tuning

Digital & Analog tuning

Analog tuning

Initial Setting

Clock Setting

- - / - - / - - - - ( - - - )

- - : - -

General Setting

Playback
Display
Video
Recording
Clock
Channel
DivX
HDMI
Reset All

Auto Tuning (DVB & ANALOG)
DVB Channel Setup
ANALOG Channel Setup

E9NG1BD_EN.book Page 23 Monday, April 7, 2008 5:54 PM