Installing batteries in the remote control, Switching dvd / vcr mode, About the remote control – Toshiba DVR18 User Manual
Page 15: On/standby, Rec dubbing program vcr/dvd rec, Caution
15
EN
In
trod
uct
ion
Connecti
o
ns
Bas
ic Setup
P
layback
Ed
iti
n
g
V
CR Fu
ncti
on
s
O
th
ers
Fu
nc
ti
on
Set
u
p
Recordi
n
g
Installing Batteries in the
Remote Control
Install two R6 (AA) batteries (supplied) into the
remote control, carefully match with the polarity
indicated inside the battery compartment.
Caution
• Incorrect use of batteries can result in hazards such
as leakage and bursting.
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
• Make sure that the plus (+) and minus (-) ends of
each battery match the indications inside the battery
compartment.
• Remove batteries if the equipment will not be used
for a month or more.
• When disposing of used batteries, please comply
with governmental regulations or the public
instructions for environmental protection that apply
in your country or area.
• Do not recharge, short-circuit, heat, burn or
disassemble batteries.
About the Remote Control
• Make sure there is no obstacle between the remote
control and the remote control sensor on the unit.
• Use within the operating range and angle as shown.
• The maximum operable range as follows:
Line of sight:
approximately 7 m
Either side of centre: approximately 7 m within
30 degrees
• Remote control operation may become unreliable if
the remote control sensor of the unit is being
exposed by the strong sunlight or fluorescent light.
• Remote controls for different devices can interfere
with each other. Be careful when using remote
controls for other equipment located close to the
unit.
• Replace the batteries when the operating range of
the remote control reduces.
Switching DVD / VCR mode
Because this product is a combination of DVD
recorder and VCR recorder, you must select which
component you want to operate first.
Press [DVD] on the remote control.
Press [VCR] on the remote control.
Note
• You can also press [VCR/DVD] on the front panel to
switch between DVD and VCR mode.
2
1
3
ON/STANDBY
VCR
REC
DUBBING
PROGRAM
VCR/DVD
REC
DVD
DVD
VCR
PAL
DVD/VIDEO CASSETTE RECORDER D-VR18DT
DVD -RW/R +RW/R RECORDING
O
O
Within about
7 m
Remote control
DVD
VCR
ON/STANDBY
VCR
REC
DUBBING
PROGRAM
VCR/DVD
REC
DVD
DVD
VCR
PAL
DVD/VIDEO CASSETTE RECORDER D-VR18DT
DVD -RW/R +RW/R RECORDING
VCR/DVD
DVD
VCR
.@/:
OPEN/
CLOSE
INPUT
SELECT
HDMI
ABC
DEF
GHI
JKL
MNO
PROG.
PQRS
TUV
WXYZ
TIME SLIP
SAT.LINK
SPACE
CLEAR
INFO
TEXT
AUDIO
SUBTITLE
GUIDE
TOP MENU
DISC MENU
ENTER
/OK
DISPLAY
RETURN
/BACK
SEARCH
REV
PLAY
FWD
SKIP
STOP
SKIP
PAUSE
VCR
DVD
INSTANT SKIP
DUBBING
REC
REC MODE
SETUP
TIMER SET
SE-R0307
TIMER PROG.
1.3x/0.8xPLAY
1
2
3
4
5
6
7
8
0
9
VCR indicator
DVD indicator
DVD button
VCR button
E9NG1BD_EN.book Page 15 Monday, April 7, 2008 5:54 PM