Toshiba DVR18 - Manual (Page 85)

EN
In
troducti
on
Connecti
o
ns
Bas
ic Setup
P
layback
Ed
iti
n
g
V
CR Fu
ncti
on
s
Ot
hers
Fu
nc
ti
on
Set
u
p
Recordi
n
g
85
Playback
1
Press [ ON / STANDBY] to turn on
the unit.
To play back a tape, turn on the TV and be sure to
select the input to which the unit is connected.
2
Press [VCR].
3 Insert a pre-recorded tape, then
press [PLAY
P] to start playback.
4
During playback, press [PAUSE p].
Playback will be paused and sound will be muted.
5
Press [PLAY P] to resume playback.
6
Press [STOP S] to stop playback.
7 Press [OPEN / CLOSE O] to eject the
tape.
Note
• When a tape without record tab is inserted, the unit
will start playback automatically.
• Tracking will be automatically adjusted upon
playback. To adjust the tracking manually, press
[PROG.
/ ].
Recording and One-touch Timer
Recording (OTR)
Basic Recording
Before recording, make sure:
• The desired channel is selected by pressing
[the Number buttons] or [PROG. / ] on the
remote control.
• There is a tape with a record tab in the unit.
• Refer to pages 41 to 42 for instructions on timer
recording.
1
Turn on the unit and insert a
recordable tape.
Make sure that the TV input is set on the unit.
2 Press [VCR].
3 Select the recording mode using
[REC MODE].
• The desired recording mode is selected in SP
(standard play) or LP (long play) mode by
pressing [REC MODE].
4 Select the desired channel to record
using [PROG.
/ ] or
[the Number buttons].
5 Press [REC I] to start recording.
To temporarily stop recording or to resume it,
press [PAUSE
p].
After the unit has been in pause mode for 5
minutes, it will stop automatically to protect the
tape and the video head from damage.
6
Press [STOP S] when the recording
is completed.
VCR Functions
VCR VCR
Tape speed Recording / Playback Time
Type of tape E60 E120 E180 E240
SP mode 1 hour 2 hours 3 hours 4 hours
LP mode 2 hours 4 hours 6 hours 8 hours
VCR VCR
E9NG1BD_EN.book Page 85 Monday, April 7, 2008 5:54 PM