Pioneer DVH-P590MP - Manual (Page 79)

! An adjusted time alignment is memorized
in TA CUSTOM.
1 Press AUDIO and hold until FRONT ap-
pears in the display, then press AUDIO to
select FL.
# When you select TA OFF in TA INITIAL, you
cannot select
FL.
# If a position other than FRT-L or FRT-R is se-
lected,
CHECK POSI is displayed. To set the posi-
tion, refer to Using the position selector on page
70.
2 Press c or d to select the speaker to be
adjusted.
Each press of c or d selects the speaker in
the following order:
FL (front speaker left)
—CENT (center speaker)
—FR (front speaker right)—RR (rear speaker
right)
— RL(rear speaker left)— S/W(subwoo-
fer)
# You cannot select speakers whose size is set
at
OFF. (Refer to Setting the speaker setting on
page 76.)
3 Press a or b to adjust the distance be-
tween the selected speaker and the listen-
ing position.
Each press of a or b increases or decreases
the distance.
0.0 to 500.0 is displayed as the
distance is increased or decreased.
4 Press BAND to return to the playback
display.
Using the equalizer
The equalizer lets you adjust the equalization
to match car interior acoustic characteristics
as desired.
Recalling equalizer curves
There are seven stored equalizer curves which
you can easily recall at any time. Here is a list
of the equalizer curves:
Display Equalizer curve
POWERFUL (PWRFL) Powerful
NATURAL Natural
VOCAL Vocal
EQ FLAT Flat
CUSTOM 1 Custom 1
CUSTOM 2 Custom 2
SUPER BASS (S-BASS) Super bass
! CUSTOM 1 and CUSTOM 2 are adjusted
equalizer curves.
! When EQ FLAT is selected no supplement
or correction is made to the sound. This is
useful to check the effect of the equalizer
curves by switching alternatively between
EQ FLAT and a set equalizer curve.
% Press EQ to select the equalizer.
Press
EQ repeatedly to switch between the fol-
lowing equalizers:
POWERFUL (PWRFL)
—NATURAL—VOCAL—
EQ FLAT —CUSTOM 1—CUSTOM 2—
SUPER BASS (S-BASS)
Adjusting 3-band parametric
equalizer
For CUSTOM 1 and CUSTOM 2 equalizer
curves, you can adjust the front, rear and cen-
ter equalizer curves separately by selecting a
center frequency, an equalizer level and a Q
factor for each band.
! A separate CUSTOM 1 curve can be cre-
ated for each source.
! A CUSTOM 2 curve can be created com-
mon to all sources.
Available accessories
En
79
Section
04
A
vailable
accessories