Pioneer DVH-P590MP - Manual (Page 43)

+6 to
–4 (or –6) is displayed as the equalizer
curve is increased or decreased.
# The actual range of the adjustments are differ-
ent depending on which equalizer curve is se-
lected.
# The equalizer curve with all frequencies set to
0 cannot be adjusted.
Adjusting 7-band graphic equalizer
For CUSTOM 1 and CUSTOM 2 equalizer
curves, you can adjust the level of each band.
! A separate CUSTOM 1 curve can be cre-
ated for each source. If you make adjust-
ments when a curve other than
CUSTOM 2
is selected, the equalizer curve settings will
be memorized in
CUSTOM 1.
! A CUSTOM 2 curve can be created com-
mon to all sources. If you make adjust-
ments when the
CUSTOM 2 curve is
selected, the CUSTOM 2 curve will be up-
dated.
1 Recall the equalizer curve you want to
adjust.
See Recalling equalizer curves on the previous
page.
2 Press AUDIO to select 7-band graphic
equalizer adjustment.
Frequency and the level (e.g.,
50HZ 0) appears
in the display.
3 Press c or d to select the equalizer
band to adjust.
Each press of c or d selects equalizer bands
in the following order:
50Hz
—125Hz—315Hz—800Hz—2kHz—
5kHz
—12.5kHz
4 Press a or b to adjust the level of the
equalizer band.
Each press of a or b increases or decreases
the level of the equalization band.
+6 to
–6 is displayed as the level is increased
or decreased.
# You can then select another band and adjust
the level.
5 Press BAND to cancel the 7-band gra-
phic equalizer adjustment.
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Press AUDIO to select LOUD.
2 Press a to turn loudness on.
Loudness level (e.g., LOUD MID) appears in
the display.
# To turn loudness off, press b.
3 Press c or d to select a desired level.
LOW (low) —MID (mid)—HIGH (high)
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off.
1 Press AUDIO to select SUB.W.
# You can also select the subwoofer setting
menu by pressing
SW on the unit.
2 Press a to turn subwoofer output on.
SUB.W NOR appears in the display. Subwoo-
fer output is now on.
# If the subwoofer output phase has been set to
the reverse,
SUB.W REV will be displayed.
# To turn subwoofer output off, press b.
3 Press c or d to select the phase of sub-
woofer output.
Press c to select reverse phase and REV ap-
pears in the display. Press d to select normal
phase and
NOR appears in the display.
Operating this unit
En
43
Section
03
Operating
this
unit