Pioneer DVH-P590MP - Manual (Page 18)

Limiting stations to regional
programming
When AF is used, the regional function limits
the selection of stations broadcasting regional
programs.
1 Press FUNCTION to select REG.
2 Press a or b to turn the regional func-
tion on or off.
Notes
! Regional programming and regional networks
are organized differently depending on the
country (i.e., they may change according to
the hour, state or broadcast area).
! The preset number may disappear from the
display if the tuner tunes in a regional station
which differs from the originally set station.
! The regional function can be turned on or off
independently for each FM band.
Receiving traffic announcements
TA (traffic announcement standby) lets you re-
ceive traffic announcements automatically, no
matter what source you are listening to. TA
can be activated for both a TP station (a sta-
tion that broadcasts traffic information) or an
enhanced other network
’s TP station (a station
carrying information which cross-references
TP stations).
1 Tune in a TP or enhanced other net-
work
’s TP station.
TP indicator will light.
2 Press TA to turn traffic announcement
standby on.
# To turn traffic announcements standby off,
press
TA again.
3 Use VOLUME to adjust the TA volume
when a traffic announcement begins.
The newly set volume is stored in memory and
recalled for subsequent traffic announce-
ments.
4 Press TA while a traffic announcement
is being received to cancel the announce-
ment.
The tuner returns to the original source but re-
mains in the standby mode until
TA is pressed
again.
# You can also cancel the announcement by
pressing
SOURCE, BAND, a, b, c or d while a
traffic announcement is being received.
Notes
! You can also turn the TA function on or off in
the menu that appears with the pressing of
FUNCTION.
! The system switches back to the original
source following traffic announcement recep-
tion.
! Only TP and enhanced other network’s TP sta-
tions are tuned in during seek tuning or BSM
when TA is on.
Switching the RDS display
% Press DISPLAY repeatedly to switch be-
tween the following settings:
Program service name
—PTY information—
Frequency
PTY (program type ID code) information is
listed on the next page.
# PTY information and the frequency appear on
the display for eight seconds.
# If a PTY code of zero is received from a station
or the signal is too weak for this unit to pick up
the PTY code, you cannot switch to PTY informa-
tion display.
Operating this unit
En
18
Section
03