Operating this unit, Using balance adjustment, Using the equalizer – Pioneer DVH-P590MP User Manual
Page 42

# If you do not operate the audio function within
about 30 seconds, the display is automatically re-
turned to the source display.
Using balance adjustment
You can change the fader/balance setting so
that it can provide you an ideal listening envir-
onment in all occupied seats.
1
Press AUDIO to select FADER.
# If the balance setting has been previously ad-
justed,
BAL will be displayed.
2
Press a or b to adjust front/rear speak-
er balance.
FADER F15 to FADER R15 is displayed as the
front/rear speaker balance moves from front to
rear.
# FADER 0 is the proper setting when only two
speakers are used.
3
Press c or d to adjust left/right speaker
balance.
BAL L15 to BAL R15 is displayed as the left/
right speaker balance moves from left to right.
Using the equalizer
The equalizer lets you adjust the equalization
to match car interior acoustic characteristics
as desired.
Recalling equalizer curves
There are seven stored equalizer curves which
you can easily recall at any time. Here is a list
of the equalizer curves:
Display
Equalizer curve
POWERFUL (PWRFL)
Powerful
NATURAL
Natural
VOCAL
Vocal
Display
Equalizer curve
CUSTOM 1
Custom 1
CUSTOM 2
Custom 2
EQ FLAT
Flat
SUPER BASS (S-BASS)
Super bass
! CUSTOM 1 and CUSTOM 2 are adjusted
equalizer curves that you create. Adjust-
ments can be made with a 7-band graphic
equalizer.
! When EQ FLAT is selected no supplement
or correction is made to the sound. This is
useful to check the effect of the equalizer
curves by switching alternatively between
EQ FLAT and a set equalizer curve.
% Press EQ to select the equalizer.
Press
EQ repeatedly to switch between the fol-
lowing equalizers:
POWERFUL (PWRFL)
—NATURAL—VOCAL—
CUSTOM 1
—CUSTOM 2—EQ FLAT—
SUPER BASS (S-BASS)
Adjusting equalizer curves
The factory supplied equalizer curves, with the
exception of
EQ FLAT, can be adjusted to a
fine degree (nuance control).
1
Press AUDIO to select PWRFL.
PWRFL appears in the display.
If the equalizer curve has been previously se-
lected, the curve of that previously selected
will be displayed instead of
PWRFL.
2
Press c or d to select an equalizer
curve.
3
Press a or b to adjust the equalizer
curve.
Each press of a or b increases or decreases
the equalizer curve respectively.
Operating this unit
En
42
Section
03