Pioneer VSX-D810S - Manual (Page 37)

37
En
09
Controlling the Rest of Your System
Recalling Preset Codes
The following steps show you how to recall preset codes
for each
MULTI CONTROL button. Once the preset code
is assigned, pressing the button will automatically set the
remote to operate the respective component.
MEMO:
• Refer to “Preset Code List” on pages 43 to 49 for the
components and manufacturers available.
• Refer to “Controlling the Rest of Your System” on
pages 37 to 49 for detailed explanations on how to
operate your other components.
1
3
2
LED
TV
TVFUNC
MENU
VOLUME MASTER VOLUME
TV CONTROL
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
CHANNEL
ENTER
DISC
MPX
DISPLAY RF ATT
D.ACCESS
ST
TUNE
TUNE
ST
CLASS
ATT
BAND
/DTS DSP TEST TONE
CH SELECT CH LEVEL FUNCTION
SIGNAL SELECT
1 ¡ 4 ¢
7 8 3 ¶
EFFECT
DVD VCR CD-R TV
RCV TUN TVC CD
MIDNIGHT
LOUDNESS MUTING SETUP FL DIMMER
MULTI CONTROL
5.1 / 7.1
RECEIVER SOURCE
1 2 3
4 5 6
7 8
10
9
0
2
1 Press SETUP and hold for three seconds to
select the Preset mode.
The LED lights steadily for two seconds.
To cancel the preset mode at any time
Press
SETUP .
The remote control will also return to the previous
mode after thirty seconds of inactivity.
2 Press the MULTI CONTROL button for the
component you want to control.
Each button can be set to control one of the follow-
ing components
DVD DVD/LD player or DVR
TV TV, Satellite tuner or Cable TV tuner
VCR VCR or Digital Video Recorder
CD CD player
CD-R CD Recorder, Tape deck
or MD
TVC TV or Cable TV tuner
TUN FM/ AM tuner
3 Use the number buttons to enter the 4 digit
setup code. (see pages 43-49 for “Preset
Code List”)
The LED will blink for half a second after each digit
is input and will show a long, two second blink to
confirm a valid code has been input.
If the LED blinks three times it means an invalid code
has been input or an error has occurred. Check the
preset code list and try again. If you are not able to
input a preset code you can refer to page 38 to teach
the remote control individual commands.
The remote control returns to the previous operation
mode. It will also return to the previous mode after
thirty seconds of inactivity.
4 Repeat steps 1 through 3 to assign preset
codes for as many components as necessary.
MEMO:
• You can only input a code for the component type
written on each MULTI CONTROL button.
• If you recall a preset code for the tuner (TUN MULTI
CONTROL), you will not be able to control the built-
in tuner of this receiver using the remote. To reset the
remote to the built-in tuner, input the preset code
7008.
• To erase the preset code for the current MULTI
CONTROL button, enter 0000 as the code in step 3.
MEMO:
• The remote control will also return to the previous
mode after thirty seconds of inactivity.