Pioneer VSX-D810S - Manual (Page 31)

31
En
Tuning Directly to a Station
Sometimes, you'll already know the frequency of the
station you want to listen to. In this case, you can simply
enter the frequency directly using the number buttons
on the remote control (this function is not available
using the front panel controls of the receiver).
1 Press the MULTI CONTROL TUN button on
the remote control.
On the receiver, use the MULTI JOG to select the
tuner mode.
2 Press the BAND button to select either FM
or AM.
Each press switches the band between FM and AM.
On the receiver, pressing the
BAND button switches
between bands.
3 Press D.ACCESS ( DIRECT ACCESS ).
4 Use the number buttons to enter the fre-
quency of the radio station.
Example: To tune to 106.00 (FM), press 1 – 0 – 6 –
0 – 0
SP A STEREO
TUNED
MEMO:
• If you make a mistake while inputting the frequency,
press the D.ACCESS button twice to cancel the
frequency and start again.
2
1
3
4
CHANNEL
ENTER
DISC
MPX
DISPLAY RF ATT
D.ACCESS
ST
TUNE
TUNE
ST
CLASS
ATT
BAND
/DTS DSP TEST TONE
CH SELECT CH LEVEL FUNCTION
SIGNAL SELECT
1 ¡ 4 ¢
7 8 3 ¶
EFFECT
DVD VCR CD-R TV
RCV TUN TVC CD
MIDNIGHT
LOUDNESS MUTING SETUP FL DIMMER
MULTI CONTROL
5.1 / 7.1
RECEIVER SOURCE
1 2 3
4 5 6
7 8
10
9
0
2
Memorizing Stations
If you often listen to a particular radio station, it's
convenient to have the receiver store the frequency for
easy recall whenever you want to listen to that station.
This saves the effort of manually tuning in each time.
The VSX-D710S/D810S can memorize up to 30 stations,
stored in three banks, or classes, (A,B and C) of 10
stations each. When memorizing FM frequencies, the
receiver also stores the MPX setting (auto stereo or
mono, see p.30) and RF ATT setting (see p.30). The
process for memorizing stations is only possible from the
controls on the front panel of the receiver.
1 Tune to a station you want to memorize.
See “Finding a Station” on page 30 and “Tuning
Directly to a Station” on this page for more detail on
how to do this.
2 Press the MEMORY .
The display shows a blinking memory class.
SP A STEREO
TUNED
3 Press CLASS to select one of the three
classes.
Repeatedly pressing this button cycles through the
three available classes, A, B and C.
4 Press the STATION +/– buttons to select the
desired station memory number.
Pressing these buttons repeatedly cycles through the
10 available station memories in each class.
After choosing the location you want, the preset class
and number blink for about 5 seconds and the
receiver stores the station.
Repeat steps 1 to 4 to memorize up to 30 stations.
Using the Tuner
1 N∫m-Ы˘,?∫
3
2
4