Setting the volume level of each channel 20, Preparations, 1 press – Pioneer VSX-D810S User Manual
Page 20: 2 press 2 /dts. 3 press, 6 press, Use to set the relative volume of each channel, Master volume, Test tone

20
En
Preparations
Setting the Volume Level of
each Channel (adjusting the
speaker volume balance)
Use to set the relative volume of each channel.
1 Press
RCV.
2 Press 2/DTS.
3 Press
MASTER VOLUME +
or
–
to adjust the
volume to an appropriate level.
4 Press
TEST TONE
to output the test tone.
The test tone is output in the following order.
• Test tone is only output in 2/DTS modes. The test
tone sequence corresponds to the speaker setting
mode.
5 Adjust speaker levels so that you hear the
test tone at the same volume from each
speaker when seated in the main listening
position.
• If a speaker is deselected in the speaker setting mode
(see p. 16) then no test tone will be output for that
speaker.
• The channel level range is ± 10 dB.
• Levels can be set for each surround mode.
6 Press
TEST TONE
to turn off the test tone.
MEMO:
• Initial setting is 0 dB.
• Since the SUBWOOFER transmits an ultra-low
frequency its sound may seem quieter than it actually
is.
• The speaker volume can be adjusted without
outputting the test tone by pressing
CH LEVEL
or
CH
SELECT
button.
• You can set each sound mode individually and these
settings are completely independent of each other.
The sound modes you can set include DSP, stereo,
DVD 7.1 Ch and 2/DTS, as explained in steps
above. However, you can only use the test tone
feature when setting 2/DTS.
1
4,6
5
3
CH SELECT
TV
TVFUNC
MENU
VOLUME
MASTER VOLUME
TV CONTROL
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
CHANNEL
ENTER
DISC
MPX
DISPLAY
RF ATT
D.ACCESS
ST
TUNE
TUNE
ST
CLASS
ATT
BAND
/DTS
DSP
TEST TONE
CH SELECT
CH LEVEL
FUNCTION
SIGNAL SELECT
1
¡
4
¢
7
8
3
¶
EFFECT
DVD
VCR
CD-R
TV
RCV
TUN
TVC
CD
MIDNIGHT
LOUDNESS
MUTING
SETUP
FL DIMMER
MULTI CONTROL
5.1 / 7.1
RECEIVER
SOURCE
1
2
3
4
5
6
7
8
10
9
0
2
CT
FR
SR
FL
VSX-D710S
SW
SL
CT
FR
SR
FL
VSX-D810S
SW
SB
SL
2